Hollow Hex Plug factory introduces 6 steps to repair hydraulic hoses:

1. Find the right hose: Before doing anything else, you must determine which hose needs to be repaired. You must keep in mind how risky it is to replace a temporary hose, which is not the exact type of hydraulic hose required in the area. Before replacing a damaged hose, familiarize yourself with the precise burst pressure on that particular hydraulic hose.

2. Remove damage: Before proceeding to repair hydraulic hoses, you need to make sure that the area is completely clean. Even seemingly insignificant dirt, dust, or debris will eventually contaminate the internal parts of the hose, making repairs more expensive. Carefully check the fittings and hoses (especially the cut area) to ensure that everything is properly cleaned before proceeding with hose repairs.

3. There is an adapter at hand: When installing the hydraulic adapter to the correct port, the correct torque method must be used. This cannot be overemphasized. Tighten (tighten) the adapter in the wrong way and you may completely mess up the repair work. If you are not sure how to install hydraulic couplings, or you even need them for repair, consulting the hydraulic hose manufacturer or hiring a professional service from a hydraulic hose repair expert is best for you.

4. Make sure you have the right length: if the replacement hydraulic hose is too short, it will be stretched quickly, resulting in excessive pressure and fatigue beyond expectations. In the long run, this new hose will not only end up breaking faster, And relying on over-stretched hoses is dangerous and can lead to expensive repair costs. Although a hose that is too long is definitely better than a hose that is too short, the safest option is to use a new hose of just the right length.

5. Seal the hose correctly: The new hydraulic hose needs to be firmly sealed, otherwise the entire hydraulic system will have small holes or gaps in this area. Having to take this step "just right" seems daunting. Therefore, with the help of professional and technical personnel, all the pressure in the repair process can be eliminated. They have the experience and knowledge needed to properly seal the hose without making it too tight.

6. Confirm that there are no leaks: After the installation is complete, the last thing you need to do is to make sure that there are no leaks in the new system.