Hose Fittings And Adapters Factory introduces the use of pressure hoses:
1. Maintenance.
The pressure hose shall not be dragged on sharp or rough surfaces, and shall not be subjected to hammering, knife cutting, deformation, or crushing by vehicles. Appropriate protective measures should be taken when transporting heavy straight pipes, especially when lifting.
2. Seal test.
After the metal joint is installed, a hydraulic test should be carried out (the test pressure shall comply with the corresponding data) to ensure that the metal joint and the pressure hose are not leaking or loose. If there is no existing standard test specification, the pressure test should follow the data provided by the pressure hose manufacturer.
3. Electrostatic discharge
When installing a pressure hose with an electrostatic discharge function, it is necessary to comply with the installation specifications specified by the manufacturer. After the metal interface is installed, it needs to be tested accordingly. If the pressure hose can only withstand low resistance, a path tester or insulation controller can be used.
4. Fixing device.
The pressure hose on the fixed device should take safety measures. Safety measures must not affect the normal deformation of the pressure hose due to pressure, including (length, diameter, bend, etc.). If the pressure hose needs to withstand special mechanical force, pressure, negative pressure, or geometric deformation, please consult the manufacturer.
5. Moving parts.
The pressure hose installed on the movable part should ensure that the pressure hose will not suffer an impact, blockage, wear, and abnormal bending, folding, dragging, or twisting due to movement.
6. Reference information.
In addition to the mark, if you want to add reference information to the pressure hose, you should choose the appropriate tape. In addition, paints and coatings must not be used. The outer protective film of the pressure hose and the paint solution will have a chemical effect.
7. Maintenance.
The basic maintenance of the pressure hose is always required to ensure the performance of the pressure hose. It is necessary to pay attention to certain specific phenomena of contamination of metal joints and reaction pressure hoses, such as normal aging, erosion caused by improper use, and unexpected conditions during maintenance.
8. Repair.
Normally, it is not recommended to repair the pressure hose. If repairs are required under special circumstances, strictly follow the repair advice of the manufacturer. After the repair is completed, a pressure test is required. If one end of the pressure hose is contaminated by the cut and the rest of the pressure hose still meets the requirements of food production, the contaminated part can be removed to complete the repair.