Even with the correct selection and installation of the hose, the service life of the hose may not be extended without a proper maintenance plan. The frequency of inspecting the hose or considering replacing the hose before the actual failure occurs depends on a variety of factors, including the following factors: the severity of the application, the possibility of failure, and past hose failure experience. If you have a proper maintenance plan, you need to make sure Everyone follows the maintenance plan correctly. Next, Hose Fittings And Adapters Company introduces the maintenance method of hose fittings.

The maintenance plan also requires users to take the following measures: Check hoses or fittings correctly. If you want to know whether your hoses are at risk of failure now or in the future, you need to perform a visual inspection. The hose assembly should be visually inspected on a regular basis. If you find any abnormality in the hose or fittings, you should not continue to use the machine until the hose or fittings are further inspected, repaired, or replaced.

The following are some items that indicate the need to be replaced before using the machine: cracks or cuts on fittings or hoses burnt hoses or pipe fittings leaking soft caps or loose components during the inspection process, you may be aware of Some parts of the component require special attention because of the state. Some parts need to be replaced, tightened, or repaired.

If you encounter any of the following conditions during the inspection, you need to take the necessary measures: Excessive dirt or other accumulations leaking Clips and protective covers worn Air retention It is important to ensure that the system you are using is operating at the highest temperature. Efficiency is important. Level. It is important to check for any leaks or malfunctions. When people test systems and machines, it is important to observe safety measures to avoid any harm. Inspectors need to ensure that the hose is only operating at maximum efficiency and not exceeding its efficiency.

Because of the potential for overpressure, it is important to exercise caution when handling fluids. If you find that one or more hoses are malfunctioning, the system or machine should no longer be used and everyone should leave the area. If you just turn off the hydraulic pump, you may not be able to solve your problem. Certain components in the system may cause pressure to remain in the hose assembly. Even if the equipment is not operating as it should, the pressure will continue. If you find any holes in the hose, hydraulic oil may be sprayed out. These hydraulic oils can be very harmful, and pressure relief does not always happen quickly. After the pressure is relieved, the hose assembly can be removed. If any type of failure is identified, it is very important to remove it and replace it. In order to fully protect your system or machine, it is very important to check and replace parts correctly when you find a fault or a potential fault.