Connectors at both ends of the metal hose: The connectors mainly include threaded connections, flange connections, and quick connector connections. The three functions of the metal hose: reduce the installation stress of the pipeline, compensate for the movement of the rated position of the pipeline, and absorb the vibration of the pipeline system. The stainless steel mesh sleeve is the main pressure-bearing part of the metal braided hose installed in the pressure pipeline, and also plays the role of protecting the metal hose. According to the pressure in the pipeline and the application place, one or more layers of stainless steel wire or steel strip can be selected to weave according to certain parameters to form a high-pressure metal hose. There are two main types of stainless steel mesh sleeves: steel mesh sleeves and steel mesh sleeves. Below, is the scope of use of the connectors at both ends of Hose Fittings :
1. Recommended maximum allowable expansion per wave: full-height △α=±24mm, half-height △α=±12mm.
2. Anti-ash board: For ducts or pipes with less dust, there is no need to use ash boards for dusty flues.
3. In order to reduce the wavenumber of the bellows, 50% should be considered for cold drawing.
4. The standard half-height corrugated metal hose is suitable for occasions where the cross-sectional area is less than 4.6 square meters and the outer diameter of the flue is less than 1.5m but larger than 0.6mm. Standard full height corrugated metal hose fits all flues.