Stainless Steel Hose Fittings are prone to common faults such as falling off and leakage after continuous use for a period of time. The imported stainless steel joints of the same series of products will present many similar problems. Before using stainless steel quick connectors, you should check for leaks, cracks, nicks, and other details. If the above problem occurs, stop using it immediately and switch to a new one with no problem. Make sure the air gun valve is closed before connecting to prevent danger. Stainless steel quick connectors should not be used to connect products other than quick connectors that may be problematic, such as infiltration of metal powder or dust, as this may cause the connector to not work properly or leak. The hose should be firmly inserted into the bottom of the socket and secured with hose straps or nuts.
Prevents cracks, leaks, and falls when using hoses. If vibration or shock occurs during use, the work should be stopped immediately, if forced summary will reduce the function of the device. Pay attention to the use of stainless steel joints, and the maximum working pressure limit cannot be exceeded. The liquid used must pass through the clean liquid of the filter equipment, and there is no other residue. When working, the temperature should be controlled, and when using stainless steel quick connectors, it should be prevented the rubber seals will be worn or leaking. Do not knock, bend, or stretch the joints by human factors to prevent and cause joint damage.
1. Cost saving: When disassembling and connecting the oil circuit according to the quick connector, the posture is easy, saving time and effort, and sufficient human resources.
2. Fuel saving: When the oil circuit is disconnected, a single engineering valve on the quick connector can close the oil circuit, and the oil is not easy to discharge, preventing damage to the hydraulic oil vapor pressure.
3. Environmental maintenance: When the quick joint is cracked and joined, the oil is not easy to leak, and the ecological environment is maintained.
4. Mechanical equipment with unique design and easy transportation: It is necessary to carry large and medium-sized equipment or hydraulic tools, which should be transported by quick splicing and then assembled at the station.