.png?imageView2/2/format/jp2)
English
简体中文
China Stainless Steel Hose Fittings Wholesalers introduces the installation process of the angle valve hose:
1. Before installation, it should be confirmed that there are no blisters on the surface of the product, the wall thickness of the threaded pipe is uniform, and the switch can be rotated flexibly. Before installation, the water pipe should be dredged with water once to confirm that there is no garbage and residue in the water pipe, so as not to affect the water flow.
2. Pay attention to the winding direction. Take the angle valve as an example. When the angle valve is screwed into the inner thread of the wall, it rotates clockwise to the right. Then the direction of wrapping the remaining tape on the angle valve is counterclockwise to the left. Winding, so that when the angle valve is twisted, it will be tightened more and more tightly, and will not be loosened.
3. There is no hard and fast rule for "several layers" of winding, which can be tightened without leakage, but according to experience, it usually takes more than ten turns to ensure the sealing effect.
4. Tighten the raw material tape when wrapping, so that the raw material tape is tightly attached to the thread, as tight as possible, and do not loosen the wrapping.
5. When screwing the thread, don't screw it to the dead end. Use a little bit of strength. You don't have to screw it until it can't be screwed. Also, pay attention to the depth of the screw.
