The thermal deformation temperature of disassembling Bite Type Tube Fittings is generally 60-80 ℃, the heat resistance temperature is low, and the compressive load is low under the condition of higher working temperature, and it is easy to age. Dismantle the fitting, by moving (+) 25mm, (-) 25mm in length, to provide enough space to mount the valve or any other armature to the pipe. In order to install the valve and place the gasket on the pipe, leave a space larger than the length of the product. Installation is also simple, just use a wrench and torque wrench to tighten high-strength steel or stainless steel tie rods.
With fewer holes than flanges, the tie rods act as flange connection bolts, speeding up the process but still providing a rigid, fully end-load resistant system with a pressure rating equal to the flange's pressure rating. In fact, many harmful gases will be generated during the use of the dismantling joint. Of course, under normal conditions, these gases will not exist, and all you need to do is to keep the dismantling joint under normal conditions. The oxygen index of the disassembled connector is low, which is not good for the waterproofing of the cable. In addition, the thermal resistance coefficient of the disassembled joint is high.
The dismantling joint can be made into any length, and there is no seam between the two working wells, and it has good waterproof performance. The disassembly joint has a high thermal expansion coefficient, which is generally about 10 times that of the concrete expansion coefficient. Calculated by 100m, when the temperature in the disassembled joint increases by 40°C, the disassembled joint in the free state can be stretched by 0.00015×100×40=0.6m.
The dismantling joint is made of high-density polyethylene and modified carbon as the main materials, and the threaded pipe is produced by the withdrawal molding process. Compared with other polyethylene pipes, it has better strength, aging resistance, and corrosion resistance, and has a smaller density, generally less than 1.0g/cm3.